[2022 Updated] the latest update to Cisco 300-410 dumps and free sharing of exam practice questions from Lead4Pass

Cisco 300-410 exam ready here! Get the latest 300-410 exam exercise questions and exam dumps pdf for free! 100% pass the exam to select
the full Cisco 300-410 dumps: https://www.leads4pass.com/300-410.html the link to get VCE or PDF. All exam questions are updated!

Lead4pass offers the latest Cisco 300-410 Google Drive

[Latest updates] Free Cisco 300-410 dumps pdf download from Google Drive: https://drive.google.com/file/d/1edI9J8KRuqSiTl0BXD0FcEbZ_bSJLnRz/

[2022 Updated]: https://drive.google.com/file/d/1Hmd2m8IlFiln0lDicik9brJDd0T1caJr/

Latestvce Exam Table of Contents:

Cisco 300-410 Practice testing questions from Youtube

[2022 Updated]: Cisco 300-410 Dumps exam questions and answers online

QUESTION 1:

An engineer needs dynamic routing between two routers and is unable to establish OSPF adjacency. The output of the show ip ospf neighbor command shows that the neighbor state is EXSTART/EXCHANGE. Which action should be taken to resolve this issue?

A. match the passwords
B. match the hello timers
C. match the MTUs
D. match the network types

Correct Answer: C

The problem occurs most frequently when attempting to run OSPF between a Cisco router and another vendor\’s router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces don\’t match. If the router with the higher MTU sends a packet larger than the MTU set on the neighboring router, the neighboring router ignores the packet.

 

QUESTION 2:

Refer to the exhibit. Users report that IP addresses cannot be acquired from the DHCP server. The DHCP server is configured as shown. About 300 total nonconcurrent users are using this DHCP server, but none of them are active for more than two hours per day. Which action fixes the issue within the current resources?

A. Modify the subnet mask to the network 192.168.1.0 255.255.254.0 command in the DHCP pool
B. Configure the DHCP lease time to a smaller value
C. Configure the DHCP lease time to a bigger value
D. Add the network 192.168.2.0 255.255.255.0 command to the DHCP pool

Correct Answer: B

 

QUESTION 3:

You recently implemented SNMPv3 to increase the security of your network management system. A partial output of the show run command displays the following output that relates to SNMP.

snmp-server group NORMAL v3 noauth read NORMAL write NORMAL
Which of the following statements is true of this configuration?

A. it provides encryption, but it does not provide authentication
B. it provides neither authentication nor encryption
C. it provides authentication, but it does not provide encryption
D. it provides both authentication and encryption

Correct Answer: B

It provides neither authentication nor encryption. In SNMPv3 there are three combinations of security that can be used:

noAuthNoPriv- no authentication and no encryption noauth keyword in the configuration AuthNoPriv – messages are authenticated but not encrypted auth keyword in the configuration AuthPriv – messages are authenticated and encrypted priv keyword in the configuration In this case, the keyword noauth in the configuration indicates that no authentication and no encryption are provided. This makes the implementation no more secure than SNMPv1 or SNMPv2.

In SNMPv1 and SNMPv2, authentication is performed using a community string. When you implement SNMP using the noauth keyword, it does not use community strings for authentication. Instead it uses the configured user or group name (in this case NORMAL). Regardless, it does not provide either authentication or encryption.

Objective:
Infrastructure Services

Sub-Objective:
Configure and verify SNMP

References:
SNMP Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3850 Switches) > SNMPv3

 

QUESTION 4:

Refer to the exhibit.

A network administrator is discovering a Cisco Catalyst 9300 and a Cisco WLC 3504 in Cisco DNA Center. The Catalyst 9300 is added successfully. However, the WLC is showing the error “uncontactable” when the administrator tries to add it to Cisco DNA Center.
Which action discovers WLC in Cisco DNA Center successfully?

A. Delete the WLC 3504 from Cisco DNA Center and add it to Cisco DNA Center again.
B. Add the WLC 3504 under the hierarchy of the Catalyst 9300 connected devices.
C. Copy the .cert file from the Cisco DNA Center on the USB and upload it to the WLC 3504.
D. Copy the .pem file from the Cisco DNA Center on the USB and upload it to the WLC 3504.

Correct Answer: D

https://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/109597-csr-chained-certificates-wlc-00.html#anc12

 

QUESTION 5:

Refer to the exhibit.R4 is experiencing a packet drop when trying to reach 172.16.2.7 behind R2. Which action resolves the issue?

A. Insert a /24 floating static route on R2 toward R3 with metric 254.
B. Disable auto summarization on R2.
C. Insert a /16 floating static route on R2 toward R3 with metric 254.
D. Enable auto summarization on all three routers R1, R2, and R3.

Correct Answer: B

……

Get more up-to-date 350-801 Dumps exam questions and answers: click here

latest updated Cisco 300-410 exam questions and answers

QUESTION 1
Refer to the exhibit. An engineer configures a static route on a router, but when the engineer checks the route to the
destination, a different next-hop is chosen. What is the reason for this?

lead4pass 300-410 practice test q1

A. Dynamic routing protocols always have priority over static routes.
B. The metric of the OSPF route is lower than the metric of the static route.
C. The configured AD for the static route is higher than the AD of OSPF.
D. The syntax of the static route is not valid, so the route is not considered.
Correct Answer: C

QUESTION 2
Refer to the exhibit. An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the
summary route does not show up in the routing table. Why is the summary route missing?lead4pass 300-410 practice test q2

A. The summary-address command is used only for summarizing prefixes between areas.
B. The summary route is visible only in the OSPF database, not in the routing table.
C. There is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.
D. The summary route is not visible on this router, but it is visible on other OSPF routers in the same area.
Correct Answer: C

QUESTION 3
Refer to the exhibit. After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to spoke and hub was not establishing. Which two actions resolve the issue? (Choose two.)lead4pass 300-410 practice test q3

A. Change the mode from mode tunnel to mode transport on R3.
B. Remove the crypto isakmp key cisco address 10.1.1.1 on R2 and R3.
C. Configure the crypto isakmp key cisco address 192.1.1.1 on R2 and R3.
D. Configure the crypto isakmp key cisco address 0.0.0.0 on R2 and R3.
E. Change the mode from mode transport to mode tunnel on R2.
Correct Answer: AD

QUESTION 4
Which is a statement about IPv6 inspection is true?
A. It teams and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables
B. It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables
C. It teams and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables
D. It team and secures binding for stateless autoconfiguration addresses in Layer 2 neighbor tables.
Correct Answer: D

QUESTION 5
Which two protocols can cause TCP starvation? (Choose two)
A. TFTP
B. SNMP
C. SMTP
D. HTTPS
E. FTP
Correct Answer: AB

QUESTION 6
Which transport layer protocol is used to form LDP sessions?
A. UDP
B. SCTP
C. TCP
D. RDP
Correct Answer: C

QUESTION 7
During the maintenance window, an administrator accidentally deleted the Telnet-related configuration that permits a
Telnet connection from the inside network (Eth0/0) to the outside of the networking between Friday?Sunday night hours
only.lead4pass 300-410 practice test q7

Which configuration resolves the issue?
A. Option A
B. Option B
C. Option C
D. Option D
Correct Answer: B

QUESTION 8
Refer to the exhibit. An engineer is trying to configure local authentication on the console line, but the device is trying to
authenticate using TACACS+. Which action produces the desired configuration?lead4pass 300-410 practice test q8

A. Add the aaa authentication login default none command to the global configuration.
B. Replace the capital “C” with a lowercase “c” in the aaa authentication login Console local command.
C. Add the aaa authentication login default group tacacs+ local-case command to the global configuration.
D. Add the login authentication Console command to the line configuration
Correct Answer: D

QUESTION 9
Drag and drop the operations from the left onto the locations where the operations are performed on the right. Drag
each definition on the left to the matching term on the right.
Select and Place:lead4pass 300-410 practice test q9

QUESTION 10
Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected
through a common fiber?
A. shared risk link group-disjoint
B. linecard-disjoint
C. lowest-repair-path-metric
D. interface-disjoint
Correct Answer: B
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_eigrp/configuration/xe-3s/asr1000/ire-xe-3sasr1000/ire-ipfrr.html

QUESTION 11
Refer to the exhibit.lead4pass 300-410 practice test q11

A junior engineer updated a branch router configuration. Immediately after the change, the engineer receives calls from
the help desk that branch personnel cannot reach any network destinations. Which configuration restores service and
continues to block 10.1.1.100/32?
A. route-map FILTER-IN deny 5
B. ip prefix-list 102 seq 15 permit 0.0.0.0/32 le 32
C. ip prefix-list 102 seq 5 permit 0.0.0.0/32 le 32
D. route-map FILTER-IN permit 20
Correct Answer: D

QUESTION 12
Which method changes the forwarding decision that a router makes without first changing the routing table or
influencing the IP data plane?
A. nonbroadcast multiaccess
B. packet switching
C. policy-based routing
D. forwarding information base
Correct Answer: C

QUESTION 13
A network engineer is configuring a DHCP server to support a specialized application. Which additional DHCP feature
must be enabled to support the delivery of various additional parameters to DHCP clients?
A. modules
B. vendor extensions
C. options
D. Scopes
Correct Answer: C

Lead4Pass Cisco discount code

lead4pass coupon 2020

About lead4pass

Lead4Pass has 7 years of exam experience! A number of professional Cisco exam experts! Update exam questions throughout the year! The most complete exam questions and answers! The safest buying experience! The greatest free sharing of exam practice questions and answers!
Our goal is to help more people pass the Cisco exam! Exams are a part of life, but they are important!
In the study, you need to sum up the study! Trust Lead4Pass to help you pass the exam 100%!
about lead4pass

Summarize:

Latestvce free to share Cisco 300-410 exam exercise questions, 300-410 pdf, 300-410 exam video! Lead4pass updated exam questions and answers throughout the year!
Make sure you pass the exam successfully. Select lead4Pass 300-410 to pass Cisco 300-410 exam “Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)”.

ps.
Latest update Lead4pass 300-410 exam dumps: https://www.leads4pass.com/300-410.html (136 Q&As) [2022 updated] Total Questions: 548 Q&A

[2022 Updated]: https://drive.google.com/file/d/1Hmd2m8IlFiln0lDicik9brJDd0T1caJr/
[Latest updates] Free Cisco 300-410 Dumps pdf download from Google Drive: https://drive.google.com/file/d/1edI9J8KRuqSiTl0BXD0FcEbZ_bSJLnRz/